Interface and NAT Configuration To configure the allowed networks and NAT traversal on an interface, use the following commands: set vpn ipsec ipsec-interfaces interface eth0 set vpn ipsec nat-networks allowed-network 10.0.0.0/8 set vpn ipsec nat-networks...
Here is an example of configuring a custom application category and firewall rule to block traffic for Facebook. You could also use the default application categories or create other custom categories. configure #If DPI is not already enabled set system...
How the web proxy service can be configured via EdgeRouter’s CLI? A web proxy is useful for blocking, allowing or redirecting web traffic. There are a number of options associated with the web proxy service: hg@optusnet# set service webproxy ? administrator...
After setup DHCP servers in the network you may discover problem with a slow response from DHCP server. This is very common problem when the network use a segmentation. Usually each of VLAN required own DHCP server. To correct this problem you should...
How to configure the EdgeRouter to act as an L2TP (Layer-2 Tunnel Protocol) server for remote access. Note: These instructions assume that eth0 is your WAN (Internet) connection. Early in the configuration, a specific command should be used in case you receive a...
